Step 1 - Application

1. Start with fat-free lashes.

2. Curl your natural lashes for a seamless blend.

3. Apply a small amount of bond to the roots of your lashes, avoid applying like mascara: less is more.

4. Place each lash about 1-2 mm above your natural lash roots.

5. Continue the process until you have covered the entire eye.

6. Press the lashes firmly together with a tweezer for a firm grip.

7. During application, clean your tweezer regularly with your fingers or a tissue to prevent sticking.

8. After about 10 minutes that the lashes are applied, you can curl them again for an extra curl.

9. Allow the bond to dry for 24 hours before exposing it to water.

 

Recommendation: Applying a sealer can speed up the drying process and extend the wearing time to 7-10 days (see additional step).

 

Step 1 - Application  

1. Start with fat-free lashes.

2. Curl your natural lashes for a seamless blend.

3. Apply a small amount of bond to the roots of your lashes, avoid applying like mascara: less is more.

4. Place each lash about 1-2 mm above your natural lash roots.

5. Continue the process until you have covered the entire eye.

6. Press the lashes firmly together with a tweezer for a firm grip.

7. During application, clean your tweezer regularly with your fingers or a tissue to prevent sticking.

8. After about 10 minutes that the lashes are applied, you can curl them again for an extra curl.

9. Allow the bond to dry for 24 hours before exposing it to water.

 

Recommendation: Applying a sealer can speed up the drying process and extend the wearing time to 7-10 days (see additional step).

Step 2- sealer (optional)  

1. Once all the lashes are perfectly in place, proceed to the next step.

2. Apply a small amount of sealer to the tweezer.

3. Gently press the roots of your lashes with the tweezer (focus only on the roots).

4. Let the lashes soak for 3 hours before exposing them to water.

Step 3-remove  

1. Generously apply remover all over your lashes.

2. Allow the remover to soak in for about 5 minutes; this will loosen the glue residue.

3. Check if the eyelashes are loose; if not, let the remover stoy on a little longer. They should come off easily.

4. Apply additional remover to your natural lashes to remove any remaining residue.

5. Use makeup remover and cotton pad to get rid of any residue.

Step 4 - after care  

1. Pour a small amount of denatured alcohol (70 to 96%) into the cap of the bottle.

2. Dip the lashes in the alcohol a few times (do not soak).

3. Hold the lashes at the roots and gently brush through them with a spool oil or cotton swab. Be careful to avoid damage.

4. To get it extra fluffy, blow lightly on the lashes while brushing.

5. If glue residue still remains, repeat the cleaning process.

6. Let the lashes air dry completely before using them again.

7. With proper care, lashes can be reused 2 to 4 times.

Additional tips!  

1. Tweeze your lashes every night with the tweezer to extend the wear time.

2. Feel free to curl your lashes daily for an extra curl.

3. If you experience discomfort during application, you may be placing them too close to your lash roots. Try placing them slightly higher, about 1-2 mm from your natural lash roots.

4. It is normal to lose a few lashes after about a week, due to the natural growth cycle of your lashes. Normally these fall out unnoticed, but now they may remain attached to the lashes.

Step 2- Sealer (optional)  

1. Once all the lashes are perfectly in place, proceed to the next step.

2. Apply a small amount of sealer to the tweezer.

3. Gently press the roots of your lashes with the tweezer (focus only on the roots).

4. Let the lashes soak for 3 hours before exposing them to water.

Step 3 - Removing  

1. Generously apply remover all over your lashes.

2. Allow the remover to soak in for about 5 minutes; this will loosen the glue residue.

3. Check if the eyelashes are loose; if not, let the remover stoy on a little longer. They should come off easily.

4. Apply additional remover to your natural lashes to remove any remaining residue.

5. Use makeup remover and cotton pad to get rid of any residue.

Step 4 - after care  

1. Pour a small amount of denatured alcohol (70 to 96%) into the cap of the bottle.

2. Dip the lashes in the alcohol a few times (do not soak).

3. Hold the lashes at the roots and gently brush through them with a spool oil or cotton swab. Be careful to avoid damage.

4. To get it extra fluffy, blow lightly on the lashes while brushing.

5. If glue residue still remains, repeat the cleaning process.

6. Let the lashes air dry completely before using them again.

7. With proper care, lashes can be reused 2 to 4 times.

 

Additional tips!  

1. Tweeze your lashes every night with the tweezer to extend the wear time.

2. Feel free to curl your lashes daily for an extra curl.

3. If you experience discomfort during application, you may be placing them too close to your lash roots. Try placing them slightly higher, about 1-2 mm from your natural lash roots.

4. It is normal to lose a few lashes after about a week, due to the natural growth cycle of your lashes. Normally these fall out unnoticed, but now they may remain attached to the lashes.

Hey gorgeous! Don't forget every blink is a reminder, confidence looks stunning on you

Welcome to the family.
Welcome to the family.

Join the Celíne noé family for exclusives, discounts, updates and much more.

Join the Celíne noé family for exclusives, discounts, updates and much more.

Join the Celíne noé family for exclusives, discounts, updates and much more.

Cruelty free

Vegan

Latex free

Waterproof 

Cruelty free

Vegan

Latex free

Waterproof